--0015175cb21e90c6a10464c354b4
Content-Type: text/plain; charset=ISO-8859-1
Content-Transfer-Encoding: quoted-printable
I=B4m noticing that, sometimes, the check attempt number do not reset to "1=
"
after a recovery state, as we can see below:
[1236254782] HOST ALERT: sani6as05;DOWN;SOFT;1;No route to host
[1236254852] HOST ALERT: sani6as05;UP;SOFT;2;TCP OK - 0.519 second response
time on port 135
[1236255172] HOST ALERT: sani6as05;DOWN;SOFT;2;CRITICAL - Socket timeout
after 10 seconds =A0[1236254=
782] HOST ALERT: sani6as05;DOWN;SOFT;1;No route to host[1236254852] HOS=
T ALERT: sani6as05;UP;SOFT;2;TCP OK - 0.519 second response time on port 13=
5
[1236255172] HOST ALERT: sani6as05;DOWN;SOFT;2;CRITICAL - Socket timeout af=
ter 10 seconds=A0 <---- Should be "SOFT:1", not "SOFT:2&q=
uot;[1236255242] HOST ALERT: sani6as05;DOWN;SOFT;3;Network is unreachab=
le
[1236255312] HOST ALERT: sani6as05;DOWN;HARD;4;Network is unreachable=
=A0Is this a normal behaviour or is it a Nagios problem?=A0Than=
ks in advance,Rodney.
--0015175cb21e90c6a10464c354b4--
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]