WMI not working... new installation

[m1979]

Hi,

I just put a fresh install of Nagios, nothing else on it and tried to add WMI using two MS servers. I get the following errors for all probes in Nagios for both servers

A valid MODE and/or SUBMODE must be specified


Google does not help really... please bear in mind my linux skills are limited

[slansing]

Does your password include a "!" if so, you will have to change the password to not include that character as it will break the configurations. We can check this for you if you post your service configuration, navigate to Configure > CCM > Services > click the disk icon next to one of your wmi services and send us the output. Please block out any information you wish not to share such as passwords, front facing IP's, etc.. but, if the password or username includes special characters leave those so we can verify the above.