Dell UPS Monitoring Wizard now available

[Box293]

Hello fellow Nagios XI users. I have created a Dell UPS Monitoring Wizard that is available for download from the Nagios Exchange.

This Wizard allows you to monitor Dell UPS via a network mananagement card. Specifically this is for the UPS devices manufactured by Eaton for Dell.

You can monitor the following:

• Alarm Status
  Battery Monitoring Status
  Battery Remaining
  Battery Test Status
  Firmware Version
  Firmware Version - Network Management Card
  Global Status
  Model
  Output VA Consumption
  Output Watt Consumption
  Output Watt Remaining
  Serial Number
  UPS Mode

Version Notes:
Version 2011-03-14
The first version released. Tested on Nagios XI 2009R1.4B and 2011R1.1.

Version 2011-03-26
* Plugin was updated so the battery_monitoring_status check reports a CRITICAL status if traps 11, 13, 15 or 57 are present (alerting that the UPS is either over/under AC Voltage OR Input Frequency is out of range OR UPS is on battery) (if UPS is On Battery it will NOT report a CRITICAL status if a Battery Test is in progress)
* Plugin has an alarm_status check added
* Added GNU License

Version 2011-03-28
* Corrected error checking code in wizard

Version 2012-04-23
* Added firmware_version_nic check that will report the Network Management Card Firmware Version

Any questions / suggestions / requests are always welcome.

[rdedon]

Box293,
spectacular work as always, thanks!