Port monitoring

[vtrac]

haha!! ..... Thank you .....

[fsodah]

I am still checking the issue with our Network Eng. however, I need few days to get back to you. please keep the ticket open till I get back to you.

[vtrac]

Will do ..... good luck!! ...

[fsodah]

Regarding your below request find the output:
>What is the command used to check this port?
>Nagios XI GUI > Configure > Core Config Manager > Services
>Now, select the service that is having issue > select "Common Settings" > Run check Command

[vtrac]

Hi,
So, it is using "check_rrdtraf".

As you already aware, those "in" and "out" has "0 mb/s".


Best Regards,
Vinh

[fsodah]

>>So, it is using "check_rrdtraf".
Anything is wrong with the above ...
I am still investigating the switch ports I did (enable/disable) the port but didn't change anything, I am still investigating.

[vtrac]

Hi,
I tested this on my Nagios XI and it is also using "check_rrdtraf".

Since I pointed this to a test switch so some of my "in" and "out" also has "0 mb/s" as well.


Best Regards,
Vinh

[fsodah]

>>Since I pointed this to a test switch so some of my "in" and "out" also has "0 mb/s" as well.
Do I need to use another option with the run a command?

[vtrac]

Hi,
Sorry, same command work for you before and not now.
I think something has changed in your Switch / Router.

Best Regards,
Vinh

[fsodah]

>>Sorry, same command work for you before and not now.

It was working perfectly before 2 weeks