Re: Port monitoring
Posted: Tue Apr 27, 2021 12:49 pm
haha!! ..... Thank you ..... 
Nagios Support Forum
Support for Nagios products and services
https://support.nagios.com/forum/
Port monitoring
Page 2 of 3
Re: Port monitoring
Posted: Wed Apr 28, 2021 9:36 am
I am still checking the issue with our Network Eng. however, I need few days to get back to you. please keep the ticket open till I get back to you.
Re: Port monitoring
Posted: Wed Apr 28, 2021 9:45 am
Will do ..... good luck!! ...
Re: Port monitoring
Posted: Thu Apr 29, 2021 1:51 am
Regarding your below request find the output:
>What is the command used to check this port?
>Nagios XI GUI > Configure > Core Config Manager > Services
>Now, select the service that is having issue > select "Common Settings" > Run check Command
>What is the command used to check this port?
>Nagios XI GUI > Configure > Core Config Manager > Services
>Now, select the service that is having issue > select "Common Settings" > Run check Command
Re: Port monitoring
Posted: Thu Apr 29, 2021 2:36 pm
Hi,
So, it is using "check_rrdtraf".
As you already aware, those "in" and "out" has "0 mb/s".
Best Regards,
Vinh
So, it is using "check_rrdtraf".
As you already aware, those "in" and "out" has "0 mb/s".
Best Regards,
Vinh
Re: Port monitoring
Posted: Fri Apr 30, 2021 4:53 am
>>So, it is using "check_rrdtraf".
Anything is wrong with the above ...
I am still investigating the switch ports I did (enable/disable) the port but didn't change anything, I am still investigating.
Anything is wrong with the above ...
I am still investigating the switch ports I did (enable/disable) the port but didn't change anything, I am still investigating.
Re: Port monitoring
Posted: Fri Apr 30, 2021 1:13 pm
Hi,
I tested this on my Nagios XI and it is also using "check_rrdtraf".
Since I pointed this to a test switch so some of my "in" and "out" also has "0 mb/s" as well.
Best Regards,
Vinh
I tested this on my Nagios XI and it is also using "check_rrdtraf".
Since I pointed this to a test switch so some of my "in" and "out" also has "0 mb/s" as well.
Best Regards,
Vinh
Re: Port monitoring
Posted: Fri Apr 30, 2021 3:24 pm
>>Since I pointed this to a test switch so some of my "in" and "out" also has "0 mb/s" as well.
Do I need to use another option with the run a command?
Do I need to use another option with the run a command?
Re: Port monitoring
Posted: Fri Apr 30, 2021 3:56 pm
Hi,
Sorry, same command work for you before and not now.
I think something has changed in your Switch / Router.
Best Regards,
Vinh
Sorry, same command work for you before and not now.
I think something has changed in your Switch / Router.
Best Regards,
Vinh
Re: Port monitoring
Posted: Sat May 01, 2021 4:38 am
>>Sorry, same command work for you before and not now.
It was working perfectly before 2 weeks
It was working perfectly before 2 weeks