Nagios Support Forum

Okay, so I figured it out... I was using the incorrect service name when I was was using the gui interface. I went back into the service check config and used the following:

check_xi_service_nsclient!!SERVICESTATE!-l 'service here' -d SHOWALL

This will monitor the service provided that you use the correct service name where it states service here. Using single quotes allows you to add service names with spaces.

Excellent snchestnut01

Any additional question feel free to reach us any time.

Are we good to mark this one as resolved then?

Yes, Please do. Thank you very much for your help.