------=_Part_28561_10412747.1197302408834
Content-Type: text/plain; charset=ISO-8859-1
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
Hi,
installed Nagios 3.0b7 on a FreeBSD 6.2 based system.
With the default config samples Nagios starts up and becomes a daemon.
Within a couple of minutes the CPU load reached 99.07
91306 nagios 1 120 0 2420K 1900K CPU1 1 585:37 99.02% nagios
The machine is a dual CPU Dell 1650 rackmount box
The nagios cgi web page never shows the example host going to a UP state.
It always stays "PENDING" for checks.
Not sure what to do at this point. Thanks in advance for any help.
------=_Part_28561_10412747.1197302408834
Content-Type: text/html; charset=ISO-8859-1
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
Hi,
installed Nagios 3.0b7 on a FreeBSD 6.2 based system.
With the default config samples Nagios starts up and becomes a daemon.
Within a couple of minutes the CPU load reached 99.07
91306 nagios 1 120 0 2420K 1900K CPU1 1 585:37 99.02% nagios
The machine is a dual CPU Dell 1650 rackmount box
The nagios cgi web page never shows the example host going to a UP state. It always stays "PENDING" for checks.
Not sure what to do at this point. Thanks in advance for any help.
------=_Part_28561_10412747.1197302408834--
This post was automatically imported from historical nagios-devel mailing list archives
Original poster: [email protected]