Potential Customer Watchguard Wizard

[sms380]

I'm trying to use the Watchguard Wizard to set up monitoring of our Watchguard XTM 525 firewall. So far I'm using a trial version of Nagios XL.

Currently I have setup the SNMP rule and the Setup->SNMP section in the firewall. When I run the Nagios Watchguard wizard it tells me "No ports were detected on the switch." No matter what I do I can not seem to get this working.

Please Advise I was hoping these wizards were going to make the setup much easier. So far I'm a little disappointed.

Thx SMS380

[slansing]

Do you have the correct community string and SNMP version selected?:

http://assets.nagios.com/downloads/nagi ... _Usage.pdf

You could also try running the Switch/Router wizard against it.