Potential Customer Watchguard Wizard
Posted: Mon Jun 09, 2014 4:33 pm
I'm trying to use the Watchguard Wizard to set up monitoring of our Watchguard XTM 525 firewall. So far I'm using a trial version of Nagios XL.
Currently I have setup the SNMP rule and the Setup->SNMP section in the firewall. When I run the Nagios Watchguard wizard it tells me "No ports were detected on the switch." No matter what I do I can not seem to get this working.
Please Advise I was hoping these wizards were going to make the setup much easier. So far I'm a little disappointed.
Thx SMS380
Currently I have setup the SNMP rule and the Setup->SNMP section in the firewall. When I run the Nagios Watchguard wizard it tells me "No ports were detected on the switch." No matter what I do I can not seem to get this working.
Please Advise I was hoping these wizards were going to make the setup much easier. So far I'm a little disappointed.
Thx SMS380