Page 1 of 5
backup
Posted: Tue Mar 17, 2015 8:34 pm
by pccwglobalit
i have 4 nodes clusters and i mounted them to SAME nfs. also setup repository.
but now i cannot see it is backup. how can i check the backup schedule and see if they are running?
Re: backup
Posted: Wed Mar 18, 2015 8:28 am
by pccwglobalit
i can see the backup is finished in audit report.
however, where i can find the backup?
Re: backup
Posted: Wed Mar 18, 2015 9:24 am
by jolson
My example backup repository is "/bkk/". Please review the attached picture and ensure that the areas I have circled are appearing properly in your WebGUI.
If the repository is setup properly and selected, be sure that you have pressed 'Apply Configuration'. Once that has been done, you can force the first backup from the Command Subsystem (Run the backup_maintenance job).
Re: backup
Posted: Wed Mar 18, 2015 10:25 am
by pccwglobalit
please see my screen from attachment.
i did apply configuration again.
Re: backup
Posted: Wed Mar 18, 2015 10:27 am
by jolson
I do not see your attachment - could you please attach it once more?
Re: backup
Posted: Wed Mar 18, 2015 10:43 am
by pccwglobalit
i cannot upload jpeg. it said "Sorry, the board attachment quota has been reached."
Re: backup
Posted: Wed Mar 18, 2015 10:59 am
by jolson
We have bumped the attachment limit - could you please post your attachment now?
Re: backup
Posted: Wed Mar 18, 2015 10:59 am
by pccwglobalit
Re: backup
Posted: Wed Mar 18, 2015 11:00 am
by pccwglobalit
Re: backup
Posted: Wed Mar 18, 2015 11:20 am
by jolson
Could you please get a screenshot of your 'Command Subsystem' page to us?
I would like you to log into the CLI on each of your nodes and run the following:
Code: Select all
tail -f /usr/local/nagioslogserver/var/jobs.log
We should try and force a backup to run by clicking 'Edit' next to 'backup_maintenance', and selecting the time as 'Now'. This should force a backup to begin on your nodes.