Change the status of hostsexceed time with nrpe only

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
sky1989
Posts: 2
Joined: Mon Sep 28, 2015 9:10 am

Change the status of hostsexceed time with nrpe only

Post by sky1989 »

I try to change the status of machines that date back as nagios XI (NRPE) after a exceed time when the check is outdated.

For every 2 minutes my machines go back a WinPing at 15:30 for example (in nrpe [machine to server], status information accurate, "WinPing OK - Round trip: 0 ms Packet loss: 0% packets: 5"), but if I was a disconnect this hour and 30min after I get back on my page, the status of it is still green "Up" but in the "Last check" it is a while 3:32 p.m. the others are at 16h (normal other machines are online).

The problem is that firsthand level, it is not practical to not directly see a red rectangle with "Down" as good if the check has expired for 30min bà is that the machine is offline in my case .

How to view the status "DOWN" red to a machine where the check has expired for example more than 20 minutes? (I said that in my case, I must never make check server-> machine only machine-> server)
User avatar
Box293
Too Basu
Posts: 5126
Joined: Sun Feb 07, 2010 10:55 pm
Location: Deniliquin, Australia
Contact:

Re: Change the status of hostsexceed time with nrpe only

Post by Box293 »

What version of XI are you using?
As of May 25th, 2018, all communications with Nagios Enterprises and its employees are covered under our new Privacy Policy.
sky1989
Posts: 2
Joined: Mon Sep 28, 2015 9:10 am

Re: Change the status of hostsexceed time with nrpe only

Post by sky1989 »

Nagios XI 2014R2.7
User avatar
tgriep
Madmin
Posts: 9190
Joined: Thu Oct 30, 2014 9:02 am

Re: Change the status of hostsexceed time with nrpe only

Post by tgriep »

Can you post how your check_nrpe command is defined so we can review it?
Be sure to check out our Knowledgebase for helpful articles and solutions!
Locked