NSClient - ERROR: Invalid return from command: check_pdh

[dlukinski]

Common "NSClient - ERROR: Invalid return from command: check_pdh" after installing 0.4.3
- IS there a workaround or should we move on to 0.4.4 ?

Thank you

[hsmith]

Perhaps take a look at this: https://github.com/mickem/nscp/issues/44

[dlukinski]

Perhaps take a look at this: https://github.com/mickem/nscp/issues/44

Strangely this error had disappeared after updating Components and Wizards via admin web-interface
I see no direct correlation, yet this is only change I could think of

We run 5.2.3 ever since 5.1 OVF created by you / these updates were not included into 5.2.3 and for some reason had to be semi-manual)

[rkennedy]

It may have been how the command was formatted? We would have to see this problem in action to really diagnose it though.

Are we good to mark this thread as resolved?

[dlukinski]

It may have been how the command was formatted? We would have to see this problem in action to really diagnose it though.

Are we good to mark this thread as resolved?

Yes please

[rkennedy]

Will do, feel free to open a new thread if you need any assistance in the future.