Page 1 of 1
NSClient - ERROR: Invalid return from command: check_pdh
Posted: Tue Feb 02, 2016 8:28 am
by dlukinski
Common "NSClient - ERROR: Invalid return from command: check_pdh" after installing 0.4.3
- IS there a workaround or should we move on to 0.4.4 ?
Thank you
Re: NSClient - ERROR: Invalid return from command: check_pdh
Posted: Tue Feb 02, 2016 10:39 am
by hsmith
Re: NSClient - ERROR: Invalid return from command: check_pdh
Posted: Sat Feb 13, 2016 4:03 pm
by dlukinski
Strangely this error had disappeared after updating Components and Wizards via admin web-interface
I see no direct correlation, yet this is only change I could think of
We run 5.2.3 ever since 5.1 OVF created by you / these updates were not included into 5.2.3 and for some reason had to be semi-manual)
Re: NSClient - ERROR: Invalid return from command: check_pdh
Posted: Mon Feb 15, 2016 12:07 pm
by rkennedy
It may have been how the command was formatted? We would have to see this problem in action to really diagnose it though.
Are we good to mark this thread as resolved?
Re: NSClient - ERROR: Invalid return from command: check_pdh
Posted: Tue Feb 16, 2016 1:31 pm
by dlukinski
rkennedy wrote:It may have been how the command was formatted? We would have to see this problem in action to really diagnose it though.
Are we good to mark this thread as resolved?
Yes please
Re: NSClient - ERROR: Invalid return from command: check_pdh
Posted: Tue Feb 16, 2016 2:50 pm
by rkennedy
Will do, feel free to open a new thread if you need any assistance in the future.