Configuration Wizard: NetworkRouter - No ports were detected
Posted: Fri Oct 07, 2016 8:31 am
Hello,
I try to add a bintec RS230aw Router for monitoring with the Router Configuration Wizard.
But it says no ports where detected.
I run the Troubleshooting Tip: /usr/bin/cfgmaker --show-op-down --noreversedns --zero-speed '100000000' '[email protected]:161::::1'
The result is attached.
Any idea where the problem is?
Thank you.
I try to add a bintec RS230aw Router for monitoring with the Router Configuration Wizard.
But it says no ports where detected.
I run the Troubleshooting Tip: /usr/bin/cfgmaker --show-op-down --noreversedns --zero-speed '100000000' '[email protected]:161::::1'
The result is attached.
Any idea where the problem is?
Thank you.