Nagios Support Forum

Posted: **Mon Apr 09, 2018 2:30 pm**

System:
Nagios XI Version : 5.4.11
londnms1 2.6.32-431.29.2.el6.i686 i686
CentOS release 6.5 (Final)
Gnome Installed

Hi,

Can someone please advise on the problem below:

When the bandwidth utilization goes above 50mb on a ciscio interface, the bandwidth graph on nagios shows zero bandwidth usage. If I lower the traffic rate below 50mb on the interface, the graph starts registering.

Note I am running SNMPv2 and I have done a manual SNMP walk on the mib and I can see thespecific interface counters increment.

Many Thanks

Posted: **Mon Apr 09, 2018 4:54 pm**

Did you configure this using the stock Switch/Router wizard?

Posted: **Wed Apr 11, 2018 5:41 am**

scottwilkerson wrote:Did you configure this using the stock Switch/Router wizard?

Yes I did, but this was showing zero for about 2 hours and then suddenly burst in to life.

Not sure as to exactly what is going on.

Thanks

Posted: **Wed Apr 11, 2018 7:03 am**

Maybe there really wasn't much traffic?

Can we consider this closed?

Posted: **Thu Apr 19, 2018 7:40 am**

Yes, You may close it.

Thank you

Nagios Support Forum

Polling a cisco interface - beyond 50mb the graph shows zero

Polling a cisco interface - beyond 50mb the graph shows zero

Re: Polling a cisco interface - beyond 50mb the graph shows

Re: Polling a cisco interface - beyond 50mb the graph shows

Re: Polling a cisco interface - beyond 50mb the graph shows

Re: Polling a cisco interface - beyond 50mb the graph shows