Nagios Support Forum

Installing Nagios Core on RHEL 7

I went to run the following commands:
firewall-cmd --zone=public --add-port=80/tcp
firewall-cmd --zone=public --add-port=80/tcp --permanent

And it said FirewallD is not running. Is there an issue if I skip over this part of the install?

nickanderson1982 wrote:And it said FirewallD is not running. Is there an issue if I skip over this part of the install?

No problem, you can skip it if you don't run firewalld

Thanks for the quick update.
You can close the ticket, Thanks again.

nickanderson1982 wrote:Thanks for the quick update.
You can close the ticket, Thanks again.

Locking thread