I have ports giving me errors due to bandwidth utilization being above the default threshold. How do I change that, I have some customers getting 40mbs some 60, some 50 etc.
Also i have ports that are disabled but still show as errors.
Thank you
Bandwidth errors
-
benningtonr
- Posts: 524
- Joined: Tue May 22, 2012 2:16 pm
Bandwidth errors
You do not have the required permissions to view the files attached to this post.
-
benningtonr
- Posts: 524
- Joined: Tue May 22, 2012 2:16 pm
Re: Bandwidth errors
Here are the warnings I am getting about bandwidth
You do not have the required permissions to view the files attached to this post.
-
scottwilkerson
- DevOps Engineer
- Posts: 19396
- Joined: Tue Nov 15, 2011 3:11 pm
- Location: Nagios Enterprises
- Contact:
Re: Bandwidth errors
The warning and critical levels were set when you ran the wizard
For the bandwidth levels, if you go into
Configure -> Core Config Manager -> Services -> Modify
The $ARG2$ fiels is the warning level, and the $ARG3$ field is the critical level.
For the bandwidth levels, if you go into
Configure -> Core Config Manager -> Services -> Modify
The $ARG2$ fiels is the warning level, and the $ARG3$ field is the critical level.