Nagios Support Forum

Hey guys, i wanted to get some input on this.

I have a central location where its in my data center. then i have several Slaves i want to put in the 'wild' but some locations might have slow internet . or i might not have full access to their routers / fw/ hardware only get a dhcp internal IP and thats it.

what solution can i put to 1, have the slave automatically connect to the main server , internet might be slow at time in these remote locations, and i want to eventually be able to ssh or anything to the slave later on as well through this "vpn" tunnel. hopefully ill find a solution its very important

You could just have the "Slaves" send the data up to the master by configuring Inbound/Outbound data transfers.

Would this be what you are trying to accomplish?

http://library.nagios.com/library/produ ... -nagios-xi

Well the thing is, i want to send the mysql info as well just in case. I am using Nagvis so would it work to show the status etc on the map?

we also want to be able to remote into the unit, ssh, VNC etc.

LuisN wrote:Well the thing is, i want to send the mysql info as well just in case.

I don't exactly understand what you mean by this, the outbound transfer will send all of the data for each check.

LuisN wrote:I am using Nagvis so would it work to show the status etc on the map?

It will.

LuisN wrote:we also want to be able to remote into the unit, ssh, VNC etc.

This is going to just depend on how you setup the server and network.