NagiosXI Web Interface not working after Ndoutils installed

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
amitshastri
Posts: 1
Joined: Fri Sep 04, 2020 1:51 pm

NagiosXI Web Interface not working after Ndoutils installed

Post by amitshastri »

I installed Ndoutils and after doing so I am getting an error message. The message says there is a Database Error and to try and run a script. I run the script and it goes through 3 databases however only 1 exists. It tries to repair nagios, nagiosxi, and nagiosql. Nagiosxi and nagiosql do not exist so they error when trying to be repaired. Going through the Ndoutils install these databases are never mentioned.

I'm able to connect to nagios through putty without issue, just can't access XI through the web interface. I went through this guide https://support.nagios.com/kb/article/n ... ce-25.html and it didn't resolve the issue. Any guidance would be greatly appreciated.
User avatar
lmiltchev
Bugs find me
Posts: 13589
Joined: Mon May 23, 2011 12:15 pm

Re: NagiosXI Web Interface not working after Ndoutils instal

Post by lmiltchev »

NDO is included in Nagios XI... Why were you trying to install it again?! I would recommend that you start "clean" by doing new, fresh install of Nagios XI 5.7.3. Do not try to install NDOutils afterwards!

Here's our official installation guide:

https://assets.nagios.com/downloads/nag ... -Linux.pdf
Be sure to check out our Knowledgebase for helpful articles and solutions!
Locked