Hello. I upgraded to 2012R1.4 today via the upgrade script (followed instructions on Nagios site) and now my service or host detail will not load. The little wheel just keeps spinning.
I am running CentOS release 6.2 (Final) - this was the VM image provided by Nagios, updated using yum.
Kernel 2.6.32-279.19.1.e16,x86_64
I have rebooted the server, no change. Unfortunately my knowledge of linux is pretty low, I apologize. Can someone point me in the right direction to troubleshoot this??
Thanks much.
Service detail won't load after 1.4 upgrade
-
GEAviation-PBN
- Posts: 5
- Joined: Fri Aug 17, 2012 3:13 pm
Re: Service detail won't load after 1.4 upgrade
Did you try right-click->Reload, while holding the "Shift" button? What browser are you using?
Be sure to check out our Knowledgebase for helpful articles and solutions!
-
GEAviation-PBN
- Posts: 5
- Joined: Fri Aug 17, 2012 3:13 pm
Re: Service detail won't load after 1.4 upgrade
Yes I did. I am using IE9. I will try from a different browser just in case.
-
GEAviation-PBN
- Posts: 5
- Joined: Fri Aug 17, 2012 3:13 pm
Re: Service detail won't load after 1.4 upgrade
Ok, the problem is with IE9. Everything works fine in Chrome. Thank you.
Re: Service detail won't load after 1.4 upgrade
It may also work in the IE if you change to compatibility mode.
You do not have the required permissions to view the files attached to this post.
Be sure to check out our Knowledgebase for helpful articles and solutions!