SNMP on a public IP

grobinson · Post by **grobinson** » Fri Jun 20, 2014 4:55 pm

I add my Layer 3 Force 10 S25 switch to Nagios via its public IP, and it loads and Nagios enumerates the ports correctly. However, as soon as I click Finish, he switch receives SNMP authentication errors, and the port status in nagios time out on each port even though the bandwidth does not. We have two SNMP communities and servers on the switch, and our auxiliary SNMP monitoring system reads the port status without errors. I've spoken to Force10 support, and they have verified that the configuration is fine.

Thanks!

sreinhardt · Post by **sreinhardt** » Mon Jun 23, 2014 9:54 am

Are you using the switch and router wizard for this configuration? If so which version are you on presently? Admin->Manage Wizards->Switch wizard

riyasbasheer · Post by **riyasbasheer** » Mon Jun 23, 2014 2:16 pm

Came across this post while going through the forum looking for similar issues to what we are facing - Port bandwidth is shown properly but not the status. Please see: http://support.nagios.com/forum/viewtop ... lit=wizard

PS: I hope it is okay to post a comment here.

sreinhardt · Post by **sreinhardt** » Mon Jun 23, 2014 3:11 pm

While similar in issue, I don't as of yet, think that these are related at all.

grobinson · Post by **grobinson** » Tue Jun 24, 2014 5:33 pm

I am using the Network Switch / Router wizard, version 2.0.6

tmcdonald · Post by **tmcdonald** » Wed Jun 25, 2014 8:51 am

First off let's try upgrading to 2.1.2: http://exchange.nagios.org/directory/Ad ... rd/details

Download the zip and upload in the Admin -> Manage Config Wizards page (no need to unzip).

Nagios Support Forum

SNMP on a public IP

SNMP on a public IP

Re: SNMP on a public IP

Re: SNMP on a public IP

Re: SNMP on a public IP

Re: SNMP on a public IP

Re: SNMP on a public IP