Bandwidth Usage drop down not showing all

[CBoekhuis]

Hi,

i noticed that the dropdown menu in reports-->Available Reports-->Bandwidth Usage-->View Report For: (dropdown) is not showing all lines.
I don't know if this started after the changes in mrtg a few versions ago or if i've miss someting.
I generate the config file with /usr/bin/cfgmaker and put the config in /etc/mrtg/conf.d/xxx.xxx.xxx.xxx.cfg.

I'd aspect that the drop down shoud list the new generated hosts in the drop down.

What am i doing wrong?

Regards
Christian Bakker

[tmcdonald]

What exact cfgmaker command do you run?

Does it work if you use the Network Switch / Router Wizard instead?

[CBoekhuis]

/usr/bin/cfgmaker --show-op-down --zero-speed=100000000 --snmp-options=:::::2 --noreversedns [email protected] > 192.168.xxx.xxx.cfg

When using the wizard the drop down shows up , but also generates unneccesary services for each port.

Is there a solution for that?

[slansing]

The report should only display hosts/services that are actually in XI, they need to be in the proper configuration format, it will not read any old mrtg config and automatically pull them in.

[CBoekhuis]

ok. Thanx