Check on IBM Server through IMM

[dwhitfield]

I suspect we'll need to see the communities tab as well.

Also, what's the output from XI of nmap -sU 10.0.2.122 -p 161?

[sth_bytelab]

Thanks for your answer.
I tried nmap as suggested. It works fine it get the following response:
"Host is up (0.0033s latency)
Port State Service
161/udp open snmp

Nmap done: 1 IP address (1 host up)"

The community tab looks like this:

CommunityNagios.PNG

I have tried enable all IP addresses.

[dwhitfield]

I'm not sure what that Community name is. Looking at the IMM documentation, it seems like you may have an old version of IMM. Here's the documentation I found: https://www.ibm.com/support/knowledgece ... 0y1465.pdf

Is the documentation for the version of IMM you are using available online? Can you link to it? I suspect you are using the wrong community string, but I don't know where you put the community string unless "Nagios" is the community string. I suppose you could try that.