Nagios alerting in the console

This support forum board is for support questions relating to Nagios XI, our flagship commercial network monitoring solution.
Locked
rferebee
Posts: 733
Joined: Wed Jul 11, 2018 11:37 am

Nagios alerting in the console

Post by rferebee »

Good morning,

I'm trying to figure out how to adjust my service checks to keep from going Critical until 15 minutes has passed. I thought if I set the Check Interval to 15 minutes that would do it, but the system doesn't seem to be following the 15 minute rule.

For testing, I forced an immediate check while the service I'm monitoring was running and then stopped it right after. Unfortunately, Nagios checked the service again within about 5 minutes instead of 15.

Am I missing something? Thank you.
You do not have the required permissions to view the files attached to this post.
scottwilkerson
DevOps Engineer
Posts: 19396
Joined: Tue Nov 15, 2011 3:11 pm
Location: Nagios Enterprises
Contact:

Re: Nagios alerting in the console

Post by scottwilkerson »

If you have it set to a 15 minute check interval (and applied configuration)

After forcing an immediate check, you should see in the display on the advances tab that the next check is scheduled 15 minutes our (providing that it was in an OK state with the immediate check)
Former Nagios employee
Creator:
Human Design Website
Get Your Human Design Chart
rferebee
Posts: 733
Joined: Wed Jul 11, 2018 11:37 am

Re: Nagios alerting in the console

Post by rferebee »

Ok, maybe it just took some time for the change to process. It's working as expected now. Thank you.

This can be locked.
scottwilkerson
DevOps Engineer
Posts: 19396
Joined: Tue Nov 15, 2011 3:11 pm
Location: Nagios Enterprises
Contact:

Re: Nagios alerting in the console

Post by scottwilkerson »

rferebee wrote:Ok, maybe it just took some time for the change to process. It's working as expected now. Thank you.

This can be locked.
Great!

Locking
Former Nagios employee
Creator:
Human Design Website
Get Your Human Design Chart
Locked