Support Needed - XI Update

abrist · Post by **abrist** » Tue Dec 10, 2013 12:47 pm

ancovington wrote:yourvcenterserver.yourdomain.local

Is this the actual hostname of your esx server?

ancovington · Post by **ancovington** » Tue Dec 10, 2013 1:22 pm

No, do I have to delete the host and reconfigure it to change it or can I go in the settings somewhere and change it?

abrist · Post by **abrist** » Tue Dec 10, 2013 1:32 pm

You are best off removing and recreating it.

Post by **lmiltchev** » Tue Dec 10, 2013 1:37 pm

So, you followed closely all of the documents listed below, but you are not able to see any of the hosts that have been imported, correct?

http://assets.nagios.com/downloads/nagi ... p_Tool.pdf
http://assets.nagios.com/downloads/nagi ... nto_XI.pdf
http://assets.nagios.com/downloads/nagi ... ios_XI.pdf

Do you see the configs in the hosts/services directories?

ll /usr/local/nagios/etc/hosts
ll /usr/local/nagios/etc/services

ancovington · Post by **ancovington** » Tue Dec 10, 2013 1:43 pm

Yes, I see config files, but these are the hosts and services that I added manually.

ancovington · Post by **ancovington** » Tue Dec 10, 2013 1:47 pm

Is it normal that after I added two vmware hosts full of guests that the xi server is now running a little slow?

abrist · Post by **abrist** » Tue Dec 10, 2013 1:47 pm

Did you create config files by hand on the cli or just through the interface?

abrist · Post by **abrist** » Tue Dec 10, 2013 1:48 pm

ancovington wrote:Is it normal that after I added two vmware hosts full of guests that the xi server is now running a little slow?

It all depends. How many checks did you add?

ancovington · Post by **ancovington** » Tue Dec 10, 2013 1:50 pm

I created each host individually on the Gui interface under the configure tab.

I added all of the VM checks (mem, cpu, datastore, network, etc).

abrist · Post by **abrist** » Tue Dec 10, 2013 2:47 pm

Remove the host and its services through the XI Core Config Manager.

Nagios Support Forum